Construction Measures Pressing ROBOT Piles (illustration)

CONSTRUCTION MEASURES FOR PILE PRESSING USING ROBOT

1. Test pile pressing

– Use an electronic total station to locate the pile center.

-Gather piles to construction location

-Craft the pile into the pressing position, accurately adjust the center of the pile

-Align the pile upright and press

-Press each pile stroke until the end of a pile section, connecting the pile accurately

-The last part is pressed with the negative pole. After pressing, pull out the negative pressing tool.

-Stop pressing when Pmax reaches the requirements according to the design documents.

-Conduct loading for static compression and produce results

2. Mass pressing

Similar to static test pressing

-Conduct mass pressing after experimental results are available

-Stop pressing when the pile top depth and height reach the design and the allowable pressure according to the design.

- Note:

1. Location of gathering piles
2. Cable hook part
3. Direction of pile movement
4. Arm
5. Pile
6. Load Department
7. Pile heart position

Contact information:

1. Address: No. 12, Street 27, Van Phuc Urban Area, Hiep Binh Phuoc Ward, Thu Duc City, HCMC
2. Phone number: 0915.611.337 Mr. Phuong or 0915.411.337 Mr. Quan
3. Email: [email protected] or [email protected]
4. Website: Lethycorp.com
5. Road Map: See

Tags search information: provide BTC . pile,supply square pile,round pile supply,larsen poles,construction kingpost shoring,foundation construction,lethycorp pile pressing, concrete pile pressing, larsen's cunt, cyes larsen, larsen eps, pressed iron piles, pressure on people's houses, bored pile drilling,